neuf > Harmonicas > Lone Wolf

Lone Wolf Harp Break

Description :

The Harp Break pedal provides clipping distortion with a full range of clean to hard grit. As the LEDs begin to conduct, they produce a soft clipping distortion that is very similar to vacuum tube distortion. The soft clip is visibly evident by the dim lighting of the LED on the face of the pedal, and as the DRIVE is increased the LED clips harder and begins to glow brighter : the brighter the LED, the harder the clip. The tone is very close to vacuum tube distortion but without the overtones produced by tubes. The tone is much better than typical solid state distortion created by transistors, but that is not all. The Harp Break features a 20dB BASS BOOST feature to add a fat bottom end to your tone. This pedal is a great tool to dirty up an otherwise clean amp and create distortion when going into a PA. When the pedal is not used to produce distortion, it can be used to fatten up your tone by the buffered FET input and by the added bass provided through the BASS BOOST. The Harp Break offers all of this and a money-back guarantee if you are not satisfied for any reason.
SETTINGS
The settings are very basic. For a clean tone, turn the DRIVE counterclockwise and turn clockwise as you desire more distortion. Increasing the DRIVE also increases volume, so you will need to turn the VOLUME control down to prevent feedback. It is really simple : increase DRIVE and decrease VOLUME or decrease DRIVE and increase VOLUME. The BASS BOOST will provide up to 20dB of increased level in low frequencies that provides a lot of bottom for your tone.
POWER
The Harp Break operates off of a 9V battery or a 9V DC power adapter. To make it all just a little easier Lone Wolf is offering a power supply for US and EURO customers to power your Harp Break. The AC adapter requirements are 9V DC with a minimum 200mA output and a 2.1mm x 5.5mm connector with a negative center and positive outside. The battery is switched OFF when an external power supply is used, and the unit is always powered whenever the mic is plugged in. The IN jack acts as the ON/OFF switch and the pedal is ON as long as there is a cable plugged into the IN jack.

Réserver le produit Harp Break

Pour demander la réservation de ce produit, n’hésitez pas à nous contacter
par téléphone au 02 31 85 43 34 ou via le formulaire ci-dessous.
Nous tâcherons de vous répondre dans les meilleurs délais.